Converted (not by us) Hydraulic Baler Lid Shear- does not have any hydraulic valves- and ideally needs new side cutters

This is the shear only, does not come with any power source. We powered it from a small electric hydraulic power pack, as you can see in the video it was slow because of that. Please note this could be powered by any of the following: Tractor, Excavator, Diesel Power Pack, Electric Power Pack.

As shown as per pictures. Will be sold as seen

Delivery not included, Collection ONLY with Free loading. NO RETURNS- Location is near Bradwell,Debyshire.

Please feel free to message if you have any questions

Good solid structure sliding gate-unfortunately needs repairs to the drive mechanism.

The support section is 9ft long.

Gate length is 33ft long.

Gate top is 4ft from the ground.

Sold “as is” delivery is not included, collection ONLY with free loading, no returns. location Dronfield Derbyshire.

Please feel free to message if you have any questions.

Ken Mills 70ton RDF Vertical Baler

As shown as per pictures. This plant was dismantled, transported and has been in open air storage for a number of years (the power pack has been stored undercover but unfortunately one of the main motors is missing and it will need a control panel and has a limited amount of flexible hydraulic pipes) hence ‘spares and repairs’. Will be sold as seen.

This unit has bag clamps on the discharge so the baled product is pushed into a bag.#

Delivery not included, Collection ONLY with Free loading. NO RETURNS- Location is near Bradwell,Derbyshire.

Please feel free to message if you have any questions

We purchased this unit for exporting two washing barrels to Africa pre-COVID [on a one way trip]-unfortunately the deal “fell through”.

Ideally it will need shotblast/paint/new boards/air tanks general tidy up and test.
Sold “as is” Delivery not included, Collection only with free loading. No Returns. Location Nr Buxton Derbyshire

Please feel free to message-if you have any question

This unit was part of a decommissioned washing plant-removed by ourselves-it has been stored outside for a number of years-so the motor will probably need “shop” drying out-along with checking the pump out.

Sold for Spares & Repairs- “as is” Delivery not included, Collection only with free loading. No Returns Location near Bradwell Derbyshire.

Please feel free to message-if you have any questions.

Vintage Rubber Lined-Wet Feed-Ball Mill -52″ diameter x 96 inch barrel length.

This unit has not worked for many years-it runs on [2] grease packed half bearings that appear to be ok-along with the main drive gear and gearbox pinion.

It looks like a gearbox fault stopped it working all those years ago-that will need repair-and there was no drive motor with it?

It’s rubber lined-which looks ok-and the charge of balls that were in it are included in the sale.

We made a heavy duty machinery skid-[that it’s sat-on in the photos]-is not included in it’s sale-bit will be sold later separately.

Sold “as is” Delivery is not included. Collection only with free loading. No Returns Location near Bradwell Derbyshire.

Please feel free to message-if you have any questions.

Wyma Vege Polisher (Carrot Scrubber)

As shown as per picture and video. This unit was test run a few years ago although hasn’t been tested or run since hence ‘spares and repairs’. Will be sold as seen.

Please note this unit is designed as a wet rinse as it has a water spray bar running through the centre of the drum so could have other possible industrial uses.

Delivery not included, Collection ONLY with Free loading. NO RETURNS- Location is Parkgate near Rotherham.

Please feel free to message if you have any questions

Akerman H16 DLC

The [4] modules when bolted together [a bolt in each corner]- give a very wide 18ft x 36ft long covered picking station

Kue Ken 110S Jaw Crusher
42″ x 25″

A selection of wide belt conveyors of varying lengths.

Large Sand Cyclone

Single Shaft Shredder with hydraulic pusher Feeder

ERF B Series [1975] Gardner with Fassi M9 Crane